TELESCOPIC-/WHEELLOADERS
In addition to the conventional attachment systems for implements, Hauer also offers a wide range of farm, telescopic and wheel loader attachments.
Especially for use on small farm loaders, the multicroco fork and bucket was also developed in a width of 1000 mm.
The Hauer Multicroco bucket is designed for use on compact loaders and skid-steers where
its main application is silage cutting and muck handling.
The Hauer Multicroco bucket has a curved back that helps prevent sticky materials from clogging. The bucket is 700mm deep and 580m high. Its down holder can open 1,075mm so you can fill the bucket to capacity and load towards a wall without the down holder making contact with the wall. The operating weight has been reduced to a minimum for maximum skid-steer payload utilisation. The buckets are available in widths of 1,000mm to 2,000mm to suit all loader widths.
Optional additional cutting edge
As an additional wear protection the a second cutting edge screwed below the welded cutting edge. This additional cutting edge can be turned and used on both sides.
Advantages at a glance
- Low operating weight to match all skid-steer loaders
- Generous 1,075mm jaw opening (loading towards a wall is possible)
- Versatile application (silage, manure, etc.)
- Sturdy down holder with 600mm long, curved and threaded tines
Use with wheel and telescopic loaders
Because of higher system hydraulic pressure, a pressure relief valve for the cylinders has to be mounted. Fiiting coupling plates are available on request.
The Hauer Multicroco fork is designed for use on compact loaders and skid-steers where its
main application is silage cutting and muck handling.
Attachments for different fabricats
The right attachment of different fabricats for all implements.
Further information ...
